What should we do when purchasing panel connector?

[aminaas1575]

If there is enough space, it is better to choose the rear panel mounting, as it is safer than the front mounting to prevent intentional damage. The hex nut will be inside the box after installation is completed. If space is limited, choose the front panel mounting, where the hex nut will be outside the box after installation.

Q5: There are two wire connection methods for the wire-to-wire assembly connector: soldering and screw fastening. Which one is better?
A5: The choice of wire connection method between soldering and screw fastening depends on the place of use.

The soldering type is suitable for factory operation and requires professional personnel to ensure the correct execution of the process. Otherwise, it may lead to defective products. It has higher process requirements.

The screw type is suitable for outdoor use portugal number data because it is easy to install and only requires a screwdriver. You can install it yourself. The choice between the two methods depends on the specific situation.

Q6:What should we do when buying pre-wired waterproof male to female connectors?

A6: The requirements to be considered are: application, waterproof level, current, wire cross-section and cable length.

For example: Application: Outdoor LED solar lighting project, the connector should bear 10A current, waterproof level: IP67, cable length: male 500m, female 200mm.

Q7: How to choose the right connector material, PVC or nylon?

When selecting the connector material, you need to consider the operating conditions, waterproof requirements, compatibility, certification requirements, etc. Analyze these factors to determine which material can meet the operating conditions.

Q8: Does the blackening of copper wires caused by tinning affect the normal use of the product?

A8: Minor oxidation of copper wires generally does not affect the normal use of the product as long as the outer insulation of the wire is intact and undamaged. Although copper oxidation may cause some blackening, it generally does not significantly affect current transmission and connection quality.